$68.16
-14%
$35.99
$31.19
$10.79
Will this stepper motor work as a replacement for a soyo sy42sth47-1504a used in the lulzbot mini 3d printer?
Earwigger
i originally got nema 17 with 8mm thread built in but they had not enough tork and would slip alot, thought id give theses a try and instant improvement, abit longer than standard motors so check they will fit but are still the standard 40x40mm top and bottom Update. these are so good, i just brought 2 more, so much less heat caused by these motors, barely warm compared to the others, i even lowered the ampage and have more torque if you need more torque, cooler motors and lower voltage to keep motor drivers cooler then these are definatly worth a try, will need 4 more for a delta build and these are the ones i will be using, so much better than the others
stefi
These are the best packed steppers I have ordered. Nice wire length. And will work wonderful on my mini delta project. I have 14 printer and spare motors here for each of them. I will be ordering more
yamanaka_yoshi
I purchased two of these steppers to replace the motors on my 3D printer. On the the existing motors got a bent shaft. The price was right on these, and the packing was done well. Installation was plug-and-play. They were quite in operation, and the holding torque seemed to be even a little better than spec. Overall, I am very pleased with the purchase, and will buy again for my next project.
momotani
alles gut gelaufen, danke gerne wieder
modp